The HARDOX 400 wear plate ‘s cutting technology katalor supplied

Generally, the gas with high burning speed and high burning rate is suitable for thin plate cutting, and the combustible gas with low combustion value and slow burning speed is more suitable for thick plate cutting, especially the HARDOX 400 thickness wear plate exceeds 200 mm. If natural gas is used to cut the HARDOX 400 wear plate, the cutting quality will be ideal and only the cutting speed will be met. A little lower. In contrast, acetylene is much more expensive than natural gas.

In the flame cutting process of the HARDOX 400 wear plate, the height from the cutting nozzle to the cutting surface is one of the main factors determining the cutting quality and cutting speed. Different thickness of HARDOX 400 wear plates, using different cutting parameters, should adjust the corresponding height. In order to obtain a high quality cut, the height from the cutting nozzle to the surface of the work piece must be substantially uniform throughout the cutting process.

The cutting speed of the HARDOX 400 wear plate corresponds to the burning rate of oxygen in the steel. In actual production, the cutting speed should be adjusted according to the performance parameters of the cutting nozzle, gas type and purity, HARDOX 400 wear plate material and thickness. The cutting speed directly affects the stability of the cutting process and the quality of the cutting portion.